Red & Black Buffalo Plaid

$3.49
(No reviews yet) Write a Review
Shipping:
Calculated at Checkout
Buffalo Plaid RED Heat Transfer Vinyl

12"x12" Sheet size in your choice of material: Permanent Adhesive Vinyl (Gloss 651) or Heat Transfer Vinyl

 
PERMANENT ADHESIVE VINYL (GLOSS 651) SELECTION: IMPORTANT INFORMATION
 
You use this the same way you use our Oracal 651 Gloss vinyl.
 
 
HEAT TRANSFER MATERIAL SELECTION: IMPORTANT INFORMATION

Applies to cotton, polyester and similar fabrics. HEAT PRESS RECOMMENDED FOR APPLICATION! Due to this being a professional material.

This Heat Transfer Vinyl is applied differently than our other heat transfer vinyls. It does not come with a carrier sheet.

DIRECTIONS: Cut your graphic 'right' reading with the pattern face up in your cutting/cutting mat. That is, NOT reverse/mirrored as you would our other Heat Transfer Vinyls.
 
Weed and then use a piece of transfer tape to transfer the graphic to your garment.
 
Any of the transfer tapes we offer here will work: http://www.myvinyldirect.com/transfer-tape-rolls/
 
Heat the graphic with the tape on it just long enough to allow the graphic to grab the garment. 5 seconds should do it.
 
Carefully remove the tape and place your teflon sheet or silicone sheet over the graphic and heat normally.
 
Heat Press Settings: 350 degrees for 20-24 seconds. Medium pressure. Peel warm.
 
Since this product is different than our standard Heat Transfer Vinyls it will take a little patience at first. But once you get the feel for it, it goes on easy and you will LOVE it!
 
OTHER INFORMATION:
 
We recommend you DO NOT wash your garments (shirts, etc.) before application.
Washing recommendations once applied: Inside Out.
 
[sheets sizes may vary from + or - half of an inch]

Videos Hide Videos Show Videos